Red.com Red Focus Instruction Manual download pdf (Page 49)

Build 31 v31.6.16 Beta

48 48

REDCODE 42 REDFLASH 8GB REDFLASH 16GB RED-DRIVE

RED-RAM

REDMAG

2K 2:1 ---- 90 fps 100 fps

100 fps

2K 16:9 ---- 75 fps

90 fps

2K ANA ---- 90 fps 100 fps 100 fps

3K 2:1 ---- 42 fps 48 fps 48 fps

3K 16:9 ---- 36 fps

42 fps

3K ANA ---- 42 fps

48 fps

4K 2:1 ---- 25 fps 25 fps 25 fps

4K HD ---- 25 fps 25 fps 25 fps

4K ANA ---- 25 fps 25 fps 25 fps

4.5K WS ---- 25 fps 25 fps 25 fps

TIME

When Ramp is enabled, this value specifies the transition time to be used by the camera between the

(start) Frame Rate and the End (frame) Rate. To adjust: Select TIME and twist joystick to change the hig-

hlighted DURATION box to the desired setting. Range is 1-120 seconds. Default value is 5 sec.

END RATE

When Ramp is enabled, this value specifies the final (ending) speed of the ramp in frames per second.

When a ramp transition has been completed, the camera will continue to record at the End Rate until the

end of the Recording. Range is 1- 25 fps. Default value is 25 fps.

NOTE: When in Varispeed modes the camera maintains the last exposure time selected (unless the

requested frame rate requires a shorter exposure time) to provide a constant exposure. If a variable

exposure is required set the Shutter Mode to Relative - this is a fixed angle setting.

TIME-LAPSE

The Time-lapse menu supports single frame image capture and step frame recording under the control of

an internal Intervalometer, side RECORD key or an external (GPI) trigger.

NOTE: Prior to recording in Timelapse with extended exposure times (1/ 3 rd sec or longer) it is

recommended that a fresh Black Shading routine is performed. Ensure the camera is set up in

Timelapse at the desired exposure time, then press SYSTEM > SETUP > MAINTENANCE > BLACK

SHADING to perform a Black Shading calibration. After recording Timelapse at extended exposure

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 164 165

No comments

Red.com Red Focus Instruction Manual Page 49