Red.com Red Focus Instruction Manual download pdf (Page 139)

Build 31 v31.6.16 Beta

138 138

DC POWER INPUT

The POWER input connector (A) accepts a DC voltage between +11.5 and +17V DC. When used with a

RED-BRICK 140 battery, the camera also receives battery status information. The power input is pro-

tected against reverse-polarity connection, ESD, under voltage, and over current.

View into camera Power Input connector

Mating Connector: LEMO FGG.2B.306.CLAD62Z

Pin Signal Description

+VBATT Power input, +11.5 to +17VDC

GROUND Power Return (Camera Ground)

SCL_BATT Battery pack I2C bus clock

SDA_BATT Battery pack I2C bus bi-directional data

WARNING: It is very important that both pairs of +VBATT and GROUND pins are wired up. DO NOT

fabricate power cables with just one each of +VBATT and GROUND pins wired, as this will cause

damage to the camera’s power supply; this is not covered by Warranty.

DRIVE INTERFACE

The Drive Interface (B) is a custom e-SATA and power connection for RED-DRIVE and RED-RAM media.

Due to the requirement for absolute data integrity that requires custom cable construction, the pin-out of

this interface is not published.

Contact RED technical support for details of available drive interface cable lengths.

NOTE: The Drive Interface and D.C Power Input connectors use the same connector shell size. It is

very important you do not try to force a 16-pin Drive Interface cable into the 6-pin D.C Power con-

nector, or 6-pin D.C Power cable into the 16-pin Drive Interface connector.

1 2 ... 134 135 136 137 138 139 140 141 142 143 144 ... 164 165

No comments

Red.com Red Focus Instruction Manual Page 139