Build 31 v31.6.16 Beta
JUNE 22, 2011 © 2007-2011 RED.COM INC.
143
NOTE: Displays TINT if camera is not in master / slave configuration; displays TINT, S TINT, S
WBAL, and S FLUT if cameras are in master / slave configuration.
NOTE: S TINT, S WBAL, and S FLUT provide an offset for the slave camera relative to the common
TINT, WBAL and FLUT values programmed from the Master camera. This compensates for any co-
lorimetry differences between the transmitted and reflected light paths of an optical beam-splitter.
• SHUTTER MODE and SYNCRO commands
• GENLOCK enable / disable command
• VARISPEED and RAMP commands
• TIMELAPSE commands
• LOOK commands (excluding FLUT parameter)
• ZEBRA 1/2 set up and enable / disable commands
• MEDIA FORMAT, CHANGE, RESET, and UNMOUNT commands
• PROJECT RESOLUTION, QUALITY and REDCODE command
• JAM SYNC enable / disable command
• FRAME GUIDE and USER AREA setup commands
NOTE: X POSN and Y POSN offset programmed for User Action or Title from the Master camera
will result in an equal but opposite offsets for the Slave camera.
• TEST SIGNAL commands
• USER KEY 3, 4 set up and enable / disable command
• USER KEY 5 set up and enable / disable command
FORMTATTING MEDIA
After making sure the master and slave camera each have the same size media attached, use the master
camera to format the media. Refer to APPENDIX B: MANAGING DIGITAL MEDIA.
RECORDING
The master camera initiates recording of the master AND slave cameras. Recording CANNOT be initiated
by the slave camera.
RECORD: Using RECORD key, the slave camera will enter record within +/- 2 frames of master.
GPI: Under GPI trigger, the Slave camera will enter record within +/- 1 frame of Master. This trigger must
be set up on each camera individually before powering down, connecting cameras together and powering
back up.
CLIP NAMING CONVENTIONS
CAMERA POSITION / SLATE / CAMERA ID
Under SYSTEM MENU CONTROLS > SETUP > PROGRAM > POSITION, when Master is set to CENTER,
Master and Slave clips are both labeled "C", if Master is set to LEFT, Master clips are labeled "L" and
Comments to this Manuals