Red.com Red Focus Instruction Manual download pdf (Page 143)

Build 31 v31.6.16 Beta

142 142

Use an external Ambient Clockit! or comparable device to JAM SYNC the cameras as follow:

1. Power down both cameras.

2. Connect cameras as described in CONNECTING.

3. Verify that the time base of the external timecode source matches the timebase of the project to be

recorded.

4. Power up both cameras.

5. Through the Master camera UI, enable Jam Sync (this will command the Slave camera as well). Refer

to OPERATION.

GENLOCK

Interconnecting the Master and Slave cameras via USB cable does NOT lock the sensor and video frame

reference timing between the cameras. The correct configuration for GENLOCK is to supply each camera

an external RS-170A Tri-Level Sync source and then enable GENLOCK for each camera.

Use an external Ambient Clockit! or comparable device to GENLOCK the cameras as follow:

1. Power down both cameras.

2. Connect cameras as described in CONNECTING.

3. Verify that the time base of the external timecode source matches the timebase of the project to be

recorded.

4. Power up both cameras.

5. Through the Master camera UI, enable GENLOCK (this will command the Slave camera as well). Refer

to OPERATION.

OPERATION

SETUP

When connected together in master / slave configuration, none of the controls on the slave camera will

function. When adjusting the following settings on the master camera, the same adjustments will be made

to the slave camera:

• MAGNIFY (Image Zoom) command

• SENSITIVITY (ISO rating) command

• AUTO WHITE BALANCE calculation command

• MANUAL WB command following Tungsten or Daylight or Auto WB fictions – refer to SENSOR MENU

CONTROLS > COLOR TEMP > TRIM

NOTE: Auto WB value and FLUT parameters are not locked between cameras in order to permit in-

camera correction of color shift and transmission loss through beam splitter mirror.

• TINT setting

• Addition of TRIM sub-menu to COLOR TEMP menu when cameras are in master / slave configuration

and rebooted. Refer to SENSOR MENU CONTROLS > COLOR TEMP > TRIM

1 2 ... 138 139 140 141 142 143 144 145 146 147 148 ... 164 165

No comments

Red.com Red Focus Instruction Manual Page 143