Red.com Red Focus Instruction Manual download pdf (Page 136)

Build 31 v31.6.16 Beta

135

GENLOCK INPUT

A single DIN 1.0/2.3 coaxial connector accepts a Tri-Level Sync signal for video genlocking.

When operating at 23.98, 24.00, 25.00 or 29.97 Project Time Bases, set the genlock signal generator to

SMPTE 274 progressive scan format, at the same frame rate as the project TIME BASE. Do not use PsF

or interlaced signals.

Using an Ambient ACL202CT, set dip switches as follows: D = down, U = up, R = right, L = left

NOTE: After changing any of the above dip switch settings, power cycle the Ambient ACL202CT

Lockit Box timecode unit.

Frame Rate Dip Switch Settings

23.98 fps 1D, 2U, 3D, 4D, 5U, 6U, 7U, AR, BR

24.00 fps 1D, 2U, 3U, 4D, 5U, 6U, 7U, AR, BR

25.00 fps 1U, 2U, 3U, 4D, 5U, 6U, 7U, AR, BR

29.97 fps 1D, 2D, 3U, 4D, 5U, 6U, 7U, AR, BR

When operating at 50.00 or 59.94 Project Time Bases, set the genlock signal generator to SMPTE 296

progressive scan format, at the same frame rate as the project TIME BASE.

Using an Ambient ACL202CT, set dip switches as follows:

D = Down, U = up, R = right, L = left

Frame Rate Dip Switch Settings

50.00 fps - settings not verified at this time -

59.94 fps 1D, 2D, 3U, 4D, 5U, 6D, 7U, AR, BR

Connect the camera Genlock input to the ACL202CT VIDEO/WORD output using a BNC cable.

Pin: Signal Description Direction

Center

GENLOCK SMPTE 274M-2005 Tri-level Sync In

Shield/Screen

GROUND Camera ground --

Genlock Input Signal

PROGRAM (DUAL-LINK) HD-SDI

Two DIN 1.0/2.3 connectors labeled HD-SDI support progressive scan HD Program signals.

Pin: Signal Description Direction

Center

HD-SDI SMPTE-292M HD-SDI Out

Shield/Screen

GROUND Camera ground --

Program HD-SDI Output (each connector)

1 2 ... 131 132 133 134 135 136 137 138 139 140 141 ... 164 165

No comments

Red.com Red Focus Instruction Manual Page 136