Red.com Mini-Mag System Operations Instructions download pdf (Page 16)

- 16 - MINIMAG-OP-EN

INSTALLING EDGE/ORBITZ PADS:

1. Turn on machine power.

2. Raise the Scrubdeck by depressing the Brush switch

to the UP and OFF position and turn machine power

back off.

3. Select the correct Pads that best meet your cleaning

application. Consult your local dealer for assistance.

4. Remove any Pad previously attached to the EDGE/

ORBITZ Grip Face by pulling down from the corners

(SEE BELOW).

5. Once Grip Face is clear of any Pads, place pad want-

ed for application centered on the Grip Face (This will

leave a ½’’ overhang on all sides).

6. Press upwards on the Pad to secure it in place (SEE

BELOW).

7. With Pad attached securely to Grip Face of EDGE/

ORBITZ Deck, the machine is ready to use.

LEVELING EDGE/ORBITZ DECKS:

NOTICE

All Scrubdeck’s should be level at time of machine

delivery. If machine Scrubdeck is not level - Contact your

Servicing Dealer.

1. Drive machine to a ﬂ at level surface and turn machine

off.

2. Ensure that Scrubdeck is in full upright position.

3. Turn on machine and depress the brush switch. Just

before the Scrubdeck’s EDGE/ORBITZ Pad touches

the ground, turn machine OFF.

4. Tip Machine Tank back to gain access to the

Scrubdeck’s Adjustable arms.

5. Loosen the Locking Nut (A) on the Adjustable Deck

Arms. Turn the Hexagonal Arm (B) on each side of the

Scrubdeck to level it. Use the levels built into the deck

(SEE BELOW).

6. Extending the Adjustable Arms raise the front and

lowers the rear of the Scrubdeck. After Scrubdeck has

been leveled - tighten Locking Nuts (A).

NOTICE

NEVER place aggressive Pads (Maroon Prep, Dominator

HD Strip, etc.) directly onto the Grip Face. Always use

Red or Blue Spacer pad to prevent Grip Face damage.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 43 44

No comments

Red.com Mini-Mag System Operations Instructions Page 16