Red.com Red Focus User Manual download pdf (Page 3)

BASE PRODUCTION PACK

ASSEMBLY SHOWN

WITH TOP MOUNT AND TOP HANDLE

The following instructions will outline basic assembly of the RED ONE™ camera body,

BASE PRODUCTION PACK, RED

™ LCD, REDFLASH™, RED DRIVE®, and RED

BRICK®.

When connecting cables between camera and components, align Red dots

on cable and connector and press in rmly to establish a secure connection.

Wingnuts can be indexed by pulling out and rotating to desired position. This

may be necessary during assembly to clear components.

Remove your RED ONE™ camera body and all accessories from packaging and

place on a suitable work surface preferably in a dust-free environment.

Thoroughly inspect your camera and accessories.

• If there is any physical damage to your camera or accessories, please contact us

immediately at info@red.com.

Assemble bottom plate, wing nuts and washers - do not tighten.

4. Set camera body onto bottom plate and align four (4) mounting holes - two (2) on each

side - install Allen bolts and tighten.

Slide rods through mounting holes in bottom plate until centered. Lock in place using

wing nuts.

Ensure shoulder dovetail lock is on “R” side of RED™ logo and slide into bottom plate.

Install end with RED

™ logo facing rear of camera. Secure in place by sliding lock to “D”

side of RED

™ logo.

CAMERA ASSEMBLY PROCEDURECAMERA ASSEMBLY PROCEDURE

MOUNTING HOLES

ATTACH CAMERA TO

BOTTOM PLATE

UN-LOCKED

LOCKED

*** TIP***

HAND TIGHTEN THE 4

SCREWS, THEN

SINCH TIGHT WITH

3/16 ALLEN WRENCH

1 2 3 4 5 6 7 8 ... 11 12

No comments

Red.com Red Focus User Manual Page 3